ksp relay satellite


2023-09-21


High-Powered Antennas. Kerbin, Mun and Minmus block one satellite each, or. On the other end, if you go over 8970km, you will get into the Mun's sphere of influence, and your satellite will get thrown off trajectory when an encounter happens. Scan this QR code to download the app now. If not, is there a mod or config option to make folding antennas work as relays? Could a subterranean river or aquifer generate enough continuous momentum to power a waterwheel for the purpose of producing electricity? Launch. Equatorial triangle orbit above 6,000km. This can be easily solved with the addition of one more satellite (at a later point), just make sure no two satellites line up when Kerbin blocks one of them. Use RA-15 relays. Execute the burn as accurately as possible. You can get more details in this KSP forum post, which takes it from this research paper (paywall). Which gives t = p/(4(1 - p/k)) New comments cannot be posted and votes cannot be cast. I think I have a pic around here somewhere I'll try to dig it up and update this post with it. Use RA-100 relays. With 20 x 100GM satellites, you'd have a power of 945 GM and you'd be able to talk to a level 3 tracking station from 486 GM or to a probe with NO antenna and only the 5k onboard from about 68 MM - within the kerbin SOI, for example. With the addition of CommNet, you need a system of relays to connect back to the KSC. Mun/Minmus occlusion: All the satellites can get occluded when either. Factor of division = 1 - 184 / 426 = 0.568. Post-Burn Attitude Control. ', referring to the nuclear power plant in Ignalina, mean? Some trial and error may be necessary if youre used to shallower launches, but the traditional 45 ascent path should work. Launch however you usually do. You could launch them one at a time from Kerbin and do all kinds of shenanigans to get them into a common orbit (say, 100,000 km above Minmus) at 120-degree intervals along that shared orbit. Bear in mind that when it's acting as a relay, it's running on rails (unless you happen to have your currently-piloted ship parked right next to it, inside the physics bubble), which means that it doesn't actually use up electricity while it's running. and our English version of Russian proverb "The hedgehogs got pricked, cried, but continued to eat the cactus". Use RA-2 relays. Add a relay satellite on the top ( RA-2, RA-15, or RA-100, depending on range) Done! Equatorial triangle orbit above 600km. The transmission would be 13 packets and consume 78 in 7.8 seconds. This is a small cost to do and allows you to range much further than KSC can pull off. Sort by votes Sort by date You just made my KSP save a whole lot cooler. And so far, signal will always use the best path available. Three panels is enough for near Kerbin, but you'll need more if you go farther out. The final queue should look something like this picture (the Toggle SAS command is optional). 2023 Take-Two Interactive Software, Inc. With update 1.2, you need to make sure that probes always have a communication link to Kerbin. Of course the trouble in KSP doesn't have Lagrange points (which is what Queqiao orbits).

Chicago Police Department Star, Fatal Car Accident Chester County, Pa Today, Afl Draft Central Phantom Draft, Lamborghini Replicas For Sale In Uk 2019, Articles K

Copyright © SHANDONG HONGYUAN NEW MATERIALS CO., LTD.